Submitted by Jon McPhalen (not verified) on Sat, 2008-01-05 15:00.
I've been able to run Chad's code on the Arduino but have had no success duplicating it on the SX28. The SX28 is very fast and has incredibly-tight timing so I'm wondering if the device needs some kind of timing between bytes. Any suggestions or comments in this regard are appreciated.
Timing Requirements
I've been able to run Chad's code on the Arduino but have had no success duplicating it on the SX28. The SX28 is very fast and has incredibly-tight timing so I'm wondering if the device needs some kind of timing between bytes. Any suggestions or comments in this regard are appreciated.